- Step-1: Inspect Flexplate. First inspect the flexplate, checking for runout and ring gear damage. If all is true to mark and there are no cracks around bolt holes, the flexplate may be reinstalled. Step-2: Install Reinforcement Plate. Ford calls this the flywheel reinforcement plate (PN C2OZ- 6A366-A), which must be installed with the flexplate.
- Disconnect the stop switch wire from the flywheel brake and remove the coil. Attach a replacement coil using mounting screws. Push the coil (armature) away from the flywheel and tighten one screw. Turn the flywheel so the magnets are on the opposite side from the ignition coil (armature) Place the appropriate shim between the rim of the ...
The rotation of a bolt (torque) at some point causes it to stretch (tension). Several factors affect how much tension occurs when a given amount of tightening torque is applied. The first factor is the bolt's diameter. It takes more force to tighten a 3/4-10 bolt than to tighten a 318-16 bolt because it is larger in diameter.ALL THE VIDEOS IN THE TRANSMISSION SERIES:1. Remove Y Pipe & Drive Shafts to Remove Transmission - Chevy Tahoe 02 https://youtu.be/O1krtrN6PMI2. Remove Sta... Flywheel Assembly using two of the 3/8” by 5/8” bolts. Note the orientation of the caster wheels. Tighten bolts. 3. Carefully remove the plastic bag that is covering the chain coming out of the front of the Flywheel Assembly. Allow the chain to partially unroll to the floor. Remove the twist-tie that has been put through the chain near the ... Modular OHC Cap Bolts (Tighten 1st) 22 FtLbs + 90deg Crankshaft To Engine Block All 7.5 90 10.17 Modular OHC ... Torque Converter To Flexplate/Driveplate All 26 312 35.25 ...Free online farrier coursethe washer. Install the mounting bolts and tighten evenly until the hub is fully seated on the shaft. Torque: 220-240 in lbs. This bolt can be reused up to 5 times before needing replacing. NOTE: If the right hub was replaced, then install the hub back on the pulley first and secure using the three mounting screws. 8. .
- The torque is transferred via the friction between the flexplate and convertor created by the tigthening of the bolts....that is at least the way it is being tought. 2005 GMC 2500HD REG CAB SHORT BED 4WD D/A with Suncoast IV by Mike L., 1057 McRat converter, 325/60R18 Nittos. Vice President Reg Cab Club (#32) !